TMS zl Management and Configuration Guide ST.1.0.090213

2-80
Initial Setup in Routing Mode
System Maintenance
4. Copy the image from the TFTP server and install.
5. For example, suppose that you copied the images to a TFTP server that
has the parameters shown below:
• IP address—192.168.1.13
• Filename—ST.1.0.090311.zip (copied to the root directory)
6. You would type the following:
hostswitch(tms-module-C)# copy tftp image 192.168.1.13
ST.3.2.090311.zip
7. The image is uploaded to the module, then automatically installed. When
the prompt says that the installation is finished, reboot the module to
complete the update.
hostswitch(tms-module-C)# reboot
Update the Software with USB Drive. To update the software image
using a USB drive, do the following:
1. Extract the compressed software image.
2. Transfer the extracted image folder onto a USB drive in a directory called
/services/images.
Note The first partition on the USB drive should be in FAT32 format. You can reset
the USB format, if necessary, using the HP USB Creator tool.
3. Initiate a console session with the host switch.
4. Boot to the Services OS:
hostswitch# services c 1
hostswitch(services-module-C:PR)# boot services
5. When the module comes back online, enter the Services OS again.
hostswitch# services c 1
Syntax: copy tftp image <IP address> <path/file>
Copies and installs the latest software version of the TMS zl
Module from a TFTP server.
Replace <IP address> with the IP address of the server.
Replace <path/file> with the path and filename of the software
image, including the .zip extension.