TMS zl Management and Configuration Guide ST.1.0.090213

3-38
Initial Setup in Monitor Mode
Configuring Management Access
Configure the Default Gateway
Typically, you should configure the default gateway as part of the initial set up
from the CLI; however, you can also configure the default gateway from the
Web browser interface.
Complete these steps:
1. Select Network > Routing > Static Routes.
2. Click Add Static Route.
Figure 3-20. Add Static Route Window
3. For Destination Type, select Default Gateway.
4. For Gateway Address, type the IP address of the default gateway.
5. For Metric, type the cost that you want to assign to the route (0 to 255).
6. Click OK.
7. Click Save.
Change the Operating Mode
If you would like to change the operating mode back to routing, you can do it
from the Web browser interface by completing the following steps. Remember,
however, that the module will be rebooted and the last saved startup config-
uration from that mode will be loaded.