TMS zl Management and Configuration Guide ST.1.0.090213

3-51
Initial Setup in Monitor Mode
Configuring Management Access
4. From the Write Access list, select Unrestricted (read-write) or Restricted
(read only). Select the access that corresponds with the community name
and role that you specified in steps 2 and 3.
5. Click OK.
6. Click Save.
SNMPv3
To configure SNMPv3 settings:
1. From the System > Settings > SNMP window, select Enable SNMPv3 and
click Add another user. The Add SNMPv3 User window is displayed.
Figure 3-36. Add SNMPv3 User Window
2. For User Name, type the SNMPv3 username for the account.
3. For Role, select the role of the account: Manager (read-write) or Operator
(read only).
4. For Authentication Protocol, select the protocol used for the account: MD5
or SHA.
5. For Authentication Passphrase, type the authentication passphrase for the
account.