TMS zl Management and Configuration Guide ST.1.0.090213

3-52
Initial Setup in Monitor Mode
Configuring Management Access
6. For Privacy Protocol, select the privacy protocol used for the account:
None, DES, or AES. For the manager role, you must configure privacy
settings. For the operator role, you may optionally configure privacy
settings, but are not required to do so.
7. If you selected a protocol in the previous step, for Privacy Passphrase, type
the privacy passphrase for the account.
8. Click OK.
9. Click Save.
Integrate with PCM+
You can manage the TMS zl Module through the HP ProCure Manager Plus
(PCM+) just as you can manage any other network device.
To manage your module through a PCM+, you must configure at least one
setting on the TMS zl Module first:
1. Configure SNMPv1/2c with the PCM+ server’s community names or
SNMPv3 with a management account. (See “Configure SNMP” on page
3-49.)
For more instructions on managing the TMS zl Module through PCM+, see the
ProCurve Manager Network Administrator’s Guide, version 3 or later.
To integrate with HP ProCurve Network Immunity Manager (NIM), see “Inte-
gration with HP ProCurve Network Immunity Manager” in Chapter 6: “Intru-
sion Detection and Prevention.”