TMS zl Management and Configuration Guide ST.1.0.090213

4-66
Firewall
User Authentication
17. Click OK twice, and then click Next.
18. Select Access Granted and click Next.
19. Select the check box(es) for the type of RADIUS authentication used on
your network.
20. Click Next in the next three windows.
21. Review the policy settings, and then click Finish.
22. On the TMS zl Module, create a firewall access policy that permits
RADIUS and RADIUS-ACCT traffic from the Self zone to the zone in which
your NPS resides. In most cases the NPS will be located in a management-
access zone, so policies permitting this type of traffic are configured by
default. See “Firewall Access Policies” on page 4-19.
23. On the TMS zl Module, select Network > Authentication > RADIUS.
Figure 4-49. Network > Authentication > RADIUS Window
24. For Protocol, select the protocol that your RADIUS server uses. Be sure
to select the same protocol here that you did in step 19.
25. Click Apply My Changes.
26. Click Save.
27. Click Add RADIUS Server. The Add RADIUS Server window is displayed.