TMS zl Management and Configuration Guide ST.1.0.090213

5-30
Network Address Translation
NAT Examples
.
Figure 5-14. Add NAT Policy Window—Module 2
j. Click OK.
2. Create a firewall access policy to permit the traffic from Zone1 to Zone3.
a. Click Firewall > Access Policies > Unicast.
b. Click Add a Policy.
c. For Action, select Permit Traffic.
d. For From, select ZONE1.
e. For To, select ZONE3.
f. For Service, accept the default, Any Service.
You can, of course, limit the firewall policy to allow only certain
services.
g. For Source, click Options, select Enter custom IP, IP/mask or IP-Range,
and type 192.168.8.0/21.
h. For Destination, click Options, select Enter custom IP, IP/mask or IP-
Range, and type 10.1.1.0/24.
i. Select the Enable this Policy check box to enable the access policy.