TMS zl Management and Configuration Guide ST.1.0.090213

7-30
Virtual Private Networks
IPsec VPNs
Figure 7-14. Add IKE Policy Window—Step 3 of 3
• Then, for Authentication Type, select Generic or CHAP.
At some point, you must complete these steps:
i. Configure the user group for the remote gateway. (Or you can use
a group already configured on the TMS zl Module.) See “User
Authentication” in Chapter 4: “Firewall.”
ii. Configure the username and password for the remote gateway on
either an external RADIUS server or the module itself. See “User
Authentication” in Chapter 4: “Firewall.”
iii. Remember, when you are configuring firewall access policies, to
configure policies in the remote gateway’s group that allow IKE
messages to and from the remote gateway. See “Access Policies
for an IPsec Site-to-Site VPN with IKE” on page 7-112.
15. Click Finish.
The IKE policy is displayed in the VPN > IPsec > IKEv1 Policies window.