TMS zl Management and Configuration Guide ST.1.0.090213

7-114
Virtual Private Networks
Configure Firewall Access Policies for Your VPN
d. For Service, select isakmp.
e. For Source, leave Any Address or specify the local gateway IP address.
f. For Destination, specify the remote gateway IP address.
Figure 7-89. Add Policy Window
g. Click Apply.
7. Permit traffic from the local endpoints to the remote endpoints:
a. For Action, leave the default, Permit Traffic.
b. For From, select the local zone.
c. For To, select the remote zone.
d. For Service, leave Any Service.
This is the most basic configuration. You could also create access
policies that permit only certain services.
e. For Source, specify the local IP addresses allowed to send traffic on
the VPN.
In the most basic setup, these are the same IP addresses configured
as local addresses in the IPsec traffic selector.
f. For Destination, specify the remote IP addresses which the local users
are allowed to access.