TMS zl Management and Configuration Guide ST.1.0.090213

7-115
Virtual Private Networks
Configure Firewall Access Policies for Your VPN
In the most basic setup, these are the same IP addresses configured
as remote addresses in the IPsec traffic selector.
Figure 7-90. Add Policy Window
g. Click Apply.
8. Permit traffic from the remote endpoints to the local endpoints:
a. For Action, leave the default, Permit Traffic.
b. For From, select the remote zone.
c. For To, select the local zone.
d. For Service, leave Any Address.
This is the most basic configuration. You could also create access
policies that permit only certain services.
e. For Source, specify the remote IP addresses allowed to send traffic
on the VPN.
f. For Destination, specify the local addresses which the remote users
are allowed to access.
g. Click Apply.