TMS zl Management and Configuration Guide ST.1.0.090213

7-117
Virtual Private Networks
Configure Firewall Access Policies for Your VPN
4. Permit traffic from the local endpoints to the remote endpoints:
a. For Action, leave the default, Permit Traffic.
b. For From, select the local zone.
c. For To, select the remote zone.
d. For Service, leave Any Service.
This is the most basic configuration. You could also create access
policies that permit only certain services.
e. For Source, specify the local IP addresses allowed to send traffic on
the VPN.
In the most basic setup, these are the same IP addresses configured
as local addresses in the IPsec traffic selector.
f. For Destination, specify the remote IP addresses which the local users
are allowed to access.
In the most basic setup, these are the same IP addresses configured
as remote addresses in the IPsec traffic selector.
Figure 7-91. Add Policy Window
g. Click Apply.