TMS zl Management and Configuration Guide ST.1.0.090213

7-136
Virtual Private Networks
Configure Firewall Access Policies for Your VPN
Figure 7-102. Add Policy Window
g. Click Apply.
10. If necessary, repeat step 9 to permit other traffic (for example, if you
configured multiple tunnel traffic selectors).
11. Permit remote traffic that arrives on the tunnel:
a. For Action, leave the default, Permit Traffic.
b. For From, select the tunnel zone.
c. For To, select the local zone.
d. For Service, leave Any Service.
This is the most basic configuration. You could also create access
policies that permit only certain types of traffic.
e. For Source, specify the remote IP addresses that are allowed to send
traffic on the tunnel.
f. For Destination, specify the addresses that the remote endpoints are
allowed to reach.