TMS zl Management and Configuration Guide ST.1.0.090213

7-233
Virtual Private Networks
Configure the VPN Client
Figure 7-202. Windows Vista—Filter Properties
Window > Addressing Tab
26. In the Filter Properties window, the Addressing tab should be selected.
27. For Source address, typically, leave Any IP Address selected.
Often, you want the TMS zl Module to use a single IPsec policy to negotiate
connections to multiple remote clients. In this case, you would specify
Any for the Remote Address in the IPsec policy traffic selector. On the client,
you must select Any IP Address for Source Address to match that setting.
However, if you specified a specific IP address or subnet for the Remote
Address in the module’s IPsec policy traffic selector, you can select A
specific IP Address or Subnet on the client. Then, in the boxes that are
displayed, type the same address or subnet that you configured on the
module.
28. For Destination address, select A specific IP Address or Subnet.
29. In the boxes that are displayed, type the public IP address of the TMS
module.