TMS zl Management and Configuration Guide ST.1.0.090213

9-8
Routing
Static Routing
2. Click the Static Routes tab.
3. Click Add Static Route. The Add Static Route window is displayed.
Figure 9-4. Add Default Static Route Window
4. For Destination Type, select Default Gateway.
5. For Gateway Address, type the next-hop address.
6. For Metric, type 0.
7. Click OK. The route is now displayed in the Network > Routing > Static Routes
window.
You can only configure one default route for the module. If you want to change
the default route, you must delete the existing default route and create a new
one.
Note If you are configuring dynamic routing, but you want to configure a static
default route, you must configure the static default route first. Otherwise, the
module might receive a dynamic default route, preventing you from creating
your static default route. To remove the dynamic default route, you would
need to disable dynamic routing (RIP and OSPF), which you could re-enable
after configuring your static default route.