TMS zl Management and Configuration Guide ST.1.0.090213

9-18
Routing
RIP
Figure 9-5. Network > Routing > RIP Window
2. Select the Enable RIP check box.
3. Redistribute routes:
a. Under Router Redistribution, for Default Metric, type a number between
1 and 15.
The TMS zl Module advertises redistributed routes with this metric.
You might want to raise the metric to indicate that redistributed routes
are to networks that are further away. (This setting applies only to
redistributed routes. The metric for RIP routes is determined by the
hop count and the metric configured on the VLAN.)
b. Under Router Redistribution, for Applies to, select one or more of these
check boxes:
– Connected
You must select this check box if you want the TMS zl Module to
advertise routes to its TMS VLANs even if you plan to enable RIP
on these VLANs.
– Static
Select this check box to advertise routes that were manually
added to the routing table.
–OSPF
Select this check box if your system uses both OSPF and RIP, and
you want the TMS zl Module to include routes discovered by
OSPF in RIP updates.
4. Click Apply My Changes.