TMS zl Management and Configuration Guide ST.1.0.090213

9-20
Routing
RIP
•MD5—The module and other routers in this subnet authenticate each
other with MD5 authentication.
–For Key ID, type the key ID, which must match the ID on other
routers in this subnet.
–For Key, type the key, which must match the key on other routers
in this subnet.
11. Click OK.
12. Repeat steps 5 through 11 for all of the VLANs on which you want to
enable RIP.
13. Click Save.
14. Click Apply My Changes.
Note You must set the same password or key for each router on the subnet
associated with this VLAN interface, but you can set different passwords or
keys for different interfaces.
Example RIP Setup
Figure 9-7 shows an example RIP router setup using TMS zl Modules.