TMS zl Management and Configuration Guide ST.1.0.090213

9-39
Routing
OSPF
■ Define NSSA, stub, and total stub areas
Note If you are configuring dynamic routing, but you want to configure a static
default route, you must configure the static default route first. Otherwise, the
module might receive a dynamic default route, preventing you from creating
your static default route. To remove the dynamic default route, you would
need to disable dynamic routing (RIP and OSPF), which you could re-enable
after configuring your static default route.
Enable OSPF
To enable OSPF, select Network > Routing and click the OSPF tab.
Figure 9-12. Networking > Routing > OSPF Window
1. Select the Enable OSPF check box.
2. Click Apply My Changes.