TMS zl Management and Configuration Guide ST.1.0.090213

9-43
Routing
OSPF
Figure 9-14. Enable OSPF on a VLAN Window
3. For VLAN, select a VLAN from the list. The VLANs listed are those that you
configured in “Configure Zones” in Chapter 2: “Initial Setup in Routing
Mode“ and on which OSPF has not already been enabled.
4. For Area ID, type the area to which you want to assign the VLAN.
For Area ID, you can use integer or dotted-decimal (x.x.x.x) notation. On
the OSPF routing window, the area ID will always be displayed in dotted-
decimal notation. For example, 0.0.0.1 will be displayed if you type 1 as
the area ID and 0.0.1.0 will be displayed if you type 256 as the area ID.
5. For Cost, type the cost (metric) of this route.
6. For Hello Interval, type the route’s hello interval.