TMS zl Management and Configuration Guide ST.1.0.090213

9-59
Routing
Multicast
Configuring Multicast Routing
To configure the TMS zl Module to receive multicasts, complete these steps:
1. Enable IP multicast routing.
2. Configure IP multicast routing on each VLAN that uses multicast traffic.
The TMS zl Module must implement multicast routing to keep track of which
VLANs forward packets destined to certain multicast addresses. By default,
multicast routing is disabled. To enable it, complete the following steps:
1. Select Network > Routing and click the Multicast tab.
Figure 9-24. Network > Routing > Multicast Window
2. Under Multicast Settings, select the Enable Multicast Routing check box.
3. Click Apply my changes.
4. Click Enable Multicast on VLAN. The Enable Multicast on VLAN window is
displayed.