TMS zl Management and Configuration Guide ST.1.0.090213

9-60
Routing
Multicast
Figure 9-25. Enable Multicast on VLAN Window
5. For VLAN ID, select the multicast VLAN from the list.
6. For IGMP Enabled, select yes or no.
Typically, you should select yes.
7. For DR Priority, select the priority of the TMS zl Module in DR election on
the VLAN.
8. Click OK.
9. Repeat steps 4 through 8 for each VLAN that supports multicast routing.
Note Enabling multicast on a VLAN automatically enables multicasting. If you do
not intend to enable multicasting, you must refresh the Network > Routing >
Multicast window after you have enabled multicast on a VLAN, clear the Enable
Multicast Routing check box, and apply the changes. The same is true if you
edit the multicast configuration for a VLAN on which it is enabled.
Viewing Multicast Routes
To see which multicast routes are active, follow these steps:
1. Select Network > Routing, then click the View Routes tab.
Figure 9-26. Select Multicast Routes