TMS zl Management and Configuration Guide ST.1.0.090213

A-24
Threat Management Services zl Module Command-Line Reference
Product OS Manager Context Commands
ping
This command sends an ICMP echo to a specified destination.
Syntax: ping < IP address | hostname >
Replace <IP address> with the IP address of the ping destination.
Replace <hostname> with the hostname of the ping destination.
The module displays the number of pings sent and responses received.
For example, to send a ping to a device with the IP address 192.168.115.104:
ProCurve(tms-module-<slot ID>)# ping 192.168.115.104
When you send ICMP echoes, the module displays the ping statistics to
describe the types of responses the router receives. For example, Figure A-6
shows a successful ping:
Figure A-6. Sending a Ping
If you need to halt a ping operation, press
Ctrl+Z.
This command is also available from the global configuration mode context.
Note If you cannot ping a device, check that you have configured an access policy
to allow ICMP/Echo traffic from the Self zone to the zone you are trying to ping.
snapshot
This command creates a restore point for your network. The snapshot com-
mand captures information about the following:
■ Kernel
■ Hardware
■ Log files
■ Software