TMS zl Management and Configuration Guide ST.1.0.090213

A-61
Threat Management Services zl Module Command-Line Reference
Global Configuration Context
nslookup
This command is used to learn a device’s IP address according to its hostname.
Syntax: nslookup <hostname>
Replace <hostname> with the hostname of the device for which you are
looking up the IP address.
For example, if you wanted to know the IP address for router5, you would
enter:
ProCurve(tms-module-<slot ID>)# nslookup router5
operating-mode
This command sets the operating mode. The two operating modes are:
■ Monitoring
■ Routing (default mode)
To set the operating mode, enter the following command:
Syntax: operating-mode < monitor | routing >
Changing the operating mode will cause the module to reboot. You will be
prompted to confirm the change.
page
This command enables and disables page mode. In page mode, the terminal
output will pause when it fills the screen and wait for a keystroke such as
space
or Ctrl+C.
Syntax: [no] page
password
This command changes the manager and operator passwords. To change a
password, enter the following:
Syntax: password [manager | operator]
After entering this command, you will be prompted to enter the new password,
and then confirm it. The new password cannot have more than 14 characters.