TMS zl Management and Configuration Guide ST.1.0.090213

A-73
Threat Management Services zl Module Command-Line Reference
Global Configuration Context
PIM
Figure A-11. PIM Context
From the router configuration context, you can configure PIM’s Static Ren-
dezvous Points (static RPs). To configure static RPs, enter the following
command:
Syntax: [no] router pim rp-address <IP address> <group address/prefix length>
Replace <IP address> with the IP address of the static RP.
Replace <group address/prefix length> with the IP address and prefix
length of the multicast group to which the router belongs.
To access the PIM context, enter the following:
Syntax: router pim
To verify your location in the CLI, check the prompt. In the PIM context, the
prompt is the ProCurve(tms-module-<slot ID>:pim)#.
Commands available from this context are:
■ end
■ exit
■ show
■ logout