TMS zl Management and Configuration Guide ST.1.1.100226

9-21
Routing
RIP
You must select this check box if you want the TMS zl Module to
advertise routes to its TMS VLANs even if RIP is enabled on these
VLANs.
– Static
Select this check box to advertise routes that were manually
added to the routing table.
– OSPF
Select this check box if your system uses both OSPF and RIP, and
you want the TMS zl Module to include routes discovered by
OSPF in RIP updates.
5. Click Apply My Changes.
6. Click Enable RIP on an interface. The Enable RIP on Interface window is
displayed.
Figure 9-6. Enable RIP on Interface Window
7. For Interface, select an interface from the list. The interfaces listed are
TMS VLANs and GRE tunnels (on which RIP has not already been
enabled).
To learn how to create TMS VLANs, see “Plan the Zones” in Chapter 2:
“Initial Setup in Routing Mode.” To learn how to create GRE tunnel
interfaces, see, “Configure a GRE Tunnel” in Chapter 7: “Virtual Private
Networks.”