TMS zl Management and Configuration Guide ST.1.1.100226

10-7
Troubleshooting
Basic Troubleshooting Tools
For example, if you want to know the IP address for router5, enter:
hostswitch(tms-module-C)# nslookup router5
show commands
The TMS zl Module provides a number of helpful show commands, some of
which are listed in Figure 10-2. (For more information about any of these
commands, see Appendix A, “Command-Line Reference.”)
Table 10-2. show Commands for the TMS zl Module in Routing Mode or Monitor
Mode
Command Syntax Description
show arp show arp Displays the TMS zl Module’s ARP cache
entries.
show connections show connections [sip <source IP address>]
[dip <destination IP address>] [szone
<source zone>] [dzone <destination zone>]
[pid <policy ID>]
Displays the active connections on your
network. You can view all of the active
connections, or you can view them
according to the following factors:
• Source zone
• Destination zone
• Source address
• Destination address
•Policy ID
(See also the Note following this table.)
show ip dns show ip dns Displays the DNS settings that are
configured on the module.
show ip route show ip route Displays the entries in the TMS zl Module’s
route table, including directly connected
networks, static routes, or routes learned
through Routing Information Protocol (RIP)
or Open Shortest Path First (OSPF).
show logging show logging [local [reverse] [filter id
<message ID>] [filter search <search>] [filter
severity < critical | major | minor | warning |
information>]
Displays log messages.
show management show management For monitor mode, shows the management
settings for the dedicated management
VLAN and the high availability (HA) VLAN.
For routing mode, shows the zones from
which you are managing the module.
show operating-mode show operating-mode Displays the module’s operating mode.
show running-config show running-config Displays the module’s running-
configuration.