TMS zl Management and Configuration Guide ST.1.1.100226

10-8
Troubleshooting
Basic Troubleshooting Tools
Note The show connections command displays the active connections on the mod-
ule. The connections values displayed on the Web browser interface dash-
board window show both active and passive connections. As a result, these
two connection values may be slightly different. You should not be concerned
with the difference between the two values, unless:
■ The maximum connection threshold for a zone is reached
■ The number of connections is unreasonably high
For example, Figure 10-2 shows the type of output you will see when you enter
the
show connections command.
Figure 10-2. Output for the show connections Command
If you enter the show system-information command, you will see output similar
to that shown in Figure 10-3.
show snmp show snmpv2 server
show snmpv3 server
Displays the Simple Network Management
Protocol (SNMP) v2 server settings that are
configured on the module.
Displays the SNMP v3 server settings that
are configured on the module.
show system-information show system-information Displays all globally configured and
operational system parameters.
show tech show tech Displays all of the information you will need
for troubleshooting.
show version show version Displays the version of TMS OS that is
running on the module.
Command Syntax Description