TMS zl Management and Configuration Guide ST.1.1.100226

10-105
Troubleshooting
Troubleshooting the TMS zl Module in Routing Mode
Table 10-18. capture Extended Options
You may also want to limit the number of packets that are captured. For
example, you might enter the following command to view 100 HA packets:
ProCurve(tms-module-<slot ID>: config)# capture terminal
ha pktcount 100
For more information about the capture command, see “capture” on page A-27
in Appendix A: “Command-Line Reference.”
Extended Command Option Purpose
sip <source IP address> Specifies the source IP address of the packet to be captured
dip <destination IP address> Specifies the destination IP address of the packet to be captured
host <host ip address> Specifies the IP address to match to either source or destination address
sp <source port> Specifies the source port of the packet to be captured
dp <destination port> Specifies the destination port of the packet to be captured
port <port number> Specifies that all traffic sent or received on this port will be captured.
ether <network protocol type> Specifies the network protocol of the packet to be captured
•ip
•arp
•rarp
•atalk
•aarp
• decnet
•sca
•lat
• mopdl
•moprc
•iso
•stp
•ipx
• netbeui
ip <transport protocol type> Specifies the transport protocol of the packet to be captured:
•tcp
•udp
•icmp
•igmp
•eigrp
•gre
•lt2p
•pim
•ah
•esp
•vrrp
•ospf
•multicast