TMS zl Management and Configuration Guide ST.1.1.100226

A-25
Command-Line Reference
Product OS Operator Context Commands
show version
This command shows the software version.
Syntax: show version [details]
Product OS Operator Context
Commands
The Product OS operator context features a limited number of commands that
allow an operator to collect troubleshooting information. To access the Prod-
uct OS operator context, enter the operator context of the CLI of the switch
in which the TMS zl Module. Then enter the following command:
You can also access the Products OS operator context by accessing the TMS
zl Module through SSH and logging in as a management user with operator
rights. (The SSH client must be able to contact a TMS zl Module IP
address.When the TMS zl Module operates in routing mode, the SSH client
must also be in a management zone.)
TMS zl Module Product Index and Product Name
To enter the TMS zl Module CLI’s Product OS, you must either specify the
module’s product name or product number. The product name for the TMS zl
Module is always tms-module.
Syntax: services <slot ID> < <product index> | name <product name> >
Moves you to an OS context on the module.
Replace <slot ID> with the letter for the chassis slot in which
the module is installed.
Replace <product index> with the product index assigned tot he
TMS zl Module. See
Replace <product name> with services-module. The Services OS
context is always assigned product name services-module.