TMS zl Management and Configuration Guide ST.1.1.100226

A-27
Command-Line Reference
Product OS Operator Context Commands
■ TMS zl Module
On this host switch, DCM was installed and booted first, so the host switch
assigned it index number 2. It then assigned the TMS zl Module index number 3.
Table A-3. CLI Display of Services
For example, if you want to enter the operator context for the Product OS for
the TMS zl Module in slot C, enter one of the following commands:
hostswitch> services c 3
hostswitch> services c name tms-module
To verify your location in the CLI, check the prompt. In the Product OS
operator context, the prompt is ProCurve(tms-module-<slot ID>)>.
Figure A-7. Product OS Operator Context
The following sections describe commands that are available from the oper-
ator context of the Product OS.
capture
This command shows the current packets on a specified network. This
command is useful for troubleshooting connection problems and monitoring
network activity because it allows you to see all of the packets that are moving
across particular network interfaces. You can view the output to the terminal,
or you can save the output in a pcap file.
Slot Index Description Name
C,D, E 1. Services zl Module services-module
D 2. Data Center Connection Manager dcm
C,E 3. Threat Management Services zl Module tms-module