TMS zl Management and Configuration Guide ST.1.1.100226

A-31
Command-Line Reference
Product OS Operator Context Commands
Note If you cannot ping a device, check that an access policy allows ICMP/Echo
traffic from the Self zone to the zone you are trying to ping.
snapshot
This command creates a restore point for your network. The snapshot com-
mand captures information about the following:
■ Kernel
■ Hardware
■ Log files
■ Software
■ File systems
■ Networks
■ Services
■ Miscellaneous files
■ Third-party software
To take a snapshot, type the following command:
Syntax: snapshot
traceroute
This command pings an IP address and displays the hops that the packet takes
en route to the destination.
Syntax: traceroute <IP address> [extended options]
Replace <IP address> with the IP address of the final destination to which
you want to trace the route.
The module will display a route to a destination up to 255 hops away. You can
end the traceroute process at any time by pressing
Ctrl+Z.
You can set extended options for tracing a route by typing additional keywords
after the IP address. You can specify any combination of the extended options
shown in Table A-5, and you can enter the options in any order.