TMS zl Management and Configuration Guide ST.1.1.100226

A-41
Command-Line Reference
Product OS Manager Context Commands
Figure A-10. Sending a Ping
If you need to halt a ping operation, press
Ctrl+Z.
This command is also available from the global configuration mode context.
Note If you cannot ping a device, check that you have configured an access policy
to allow ICMP/Echo traffic from the Self zone to the zone you are trying to ping.
snapshot
This command creates a restore point for your network. The snapshot com-
mand captures information about the following:
■ Kernel
■ Hardware
■ Log files
■ Software
■ File systems
■ Networks
■ Services
■ Miscellaneous files
■ Third-party software
To take a snapshot, type the following command:
Syntax: snapshot
traceroute
This command pings an IP address and displays the hops that the packet takes
en route to the destination.
Syntax: traceroute <IP address> [extended options]