TMS zl Management and Configuration Guide ST.1.1.100226

A-54
Command-Line Reference
Global Configuration Context
If you want to capture packets for a high-availability (HA) interface, include
the ha option.
If you want to capture packets on all interfaces, include the any option.
You can use the extended options to capture certain types of traffic, based on
protocol, source IP address, destination IP address, source port, or destination
port. You can specify several combinations of the extended options shown in
Table A-8, and you can enter the options in almost any order.
Table A-15. capture Extended Options
For example:
ProCurve(tms-module-<slot ID>:config)# capture terminal
vlan 100 pktcount 20
This command is also available from the Product OS manager context.
Extended Command Option Purpose
sip <source IP address> Specifies the source IP address of the packet to be captured
dip <destination IP address> Specifies the destination IP address of the packet to be captured
host <host ip address> Specifies the IP address to match to either source or destination address
sp <source port> Specifies the source port of the packet to be captured
dp <destination port> Specifies the destination port of the packet to be captured
ether <network protocol type> Specifies the network protocol of the frames to be captured
•ip
•arp
•rarp
•atalk
•aarp
• decnet
•sca
•lat
• mopdl
•moprc
•iso
•stp
•ipx
• netbeui
ip <transport protocol type> Specifies the transport protocol of the packet to be captured:
•tcp
•udp
•icmp
•igmp
•eigrp
•gre
•lt2p
•pim
•ah
•esp
•vrrp
•ospf
•multicast