TMS zl Management and Configuration Guide ST.1.1.100226

A-71
Command-Line Reference
Global Configuration Context
Table A-22. Options for the high-availability Command
high-availability active-standby
To set the cluster scheme and configure the cluster’s parameters, enter the
following command:
Syntax: high-availability active-standby cluster <cluster ID> device <device ID>
priority <device priority>] [multicast-ip <multicast address>]
Replace <cluster ID> with the cluster’s ID number (1 to 16).
Replace <device ID> with the module’s ID number within the cluster (1 to 2).
Replace <device priority> with the priority number of the device within the
cluster (1 to 255). The device with the highest number will be selected as the
cluster master, should the cluster master fail.
If you enter the multicast-ip option, replace <multicast address> with the
multicast IP address to be used by the HA protocols. If you do not enter this
option, the default multicast address, 224.0.0.18, is used.
For example, to set the cluster scheme to active standby, with a cluster ID and
device ID of 2, a device priority of 3, and the default multicast address, enter
the following command:
ProCurve(tms-module-<slot ID>:config)# high-availability
active-standby cluster 2 device 2 priority 3
high-availability multicast-ip
Use this command to set the multicast IP address to be used by HA protocols:
Syntax: high-availability multicast-ip <multicast address>
Option Result
active-standby Sets the cluster scheme to active-standby and configures
all additional parameters
multicast-ip Sets the multicast address for HA protocols
synchronize Propagates the cluster master’s startup-configuration to
the other cluster member
ip Sets the high-availability interface IP address
vlan Sets the high-availability interface vlan