TMS zl Management and Configuration Guide ST.1.1.100226

A-75
Command-Line Reference
Global Configuration Context
Syntax: [no] ip-reassembly [reassembly options]
You can specify any of the extended options shown in Table A-23, but you can
enter only one option at a time.
Table A-23. IP Reassembly Options
ips
This command configures your Intrusion Prevention System (IPS). With this
command you can configure the following IPS features:
■ Threat mitigation (according to threat-level) (Routing mode only)
■ Signatures
■ IPS web-proxy
■ Protocol anomaly settings (Routing mode only)
■ Inspection options
You can also enable or disable the IPS entirely.
ips enable
To enable the IPS, enter the following command:
Syntax: ips enable
ips disable
To disable the IPS, enter the following command:
Syntax: ips disable
Extended Command Option Purpose
max-ip-messages <maximum messages> Specifies the maximum number of allowed IP messages
to be held in buffer (1-50000)
max-fragment-count <maximum fragments> Specifies the maximum number of allowed IP fragments
to be held in buffer (1–65535)
max-packet-size <maximum size> Specifies the maximum size of the original, or
reassembled, packet in bytes (1–65535)
min-fragment-size <minimum size> Specifies the minimum size of the packet fragments in
bytes (1–65535)
timeout <seconds> Specifies the number of seconds until an unsuccessful
reassembly times out (11-120)