TMS zl Management and Configuration Guide ST.1.1.100226

A-112
Command-Line Reference
Global Configuration Context
Note For the group name, you can use up to 14 alphanumeric characters and the
following special characters: space, period, comma, hyphen, (-), exclamation
point (!), dollar sign($), asperand sign (@), asterisk (*), hash sign (#), and
underscore (_).
When creating a group name that includes spaces, you must surround the
group name with quotation marks (“). For example:
ProCurve(tms-module-<slot ID>:config)# user group “it
staff”
vlan
Enter this command from the global configuration context to:
■ Assign a VLAN to a zone
■ Assign an IP address to the VLAN
■ Configure IP routing and multicast settings on the VLAN
■ Enter the VLAN context
Note You must assign the VLAN to a zone before you can enter any other commands.
vlan <VLAN ID>
To enter the VLAN context, enter the following:
Syntax: vlan <VLAN ID>
Replace <VLAN ID> with the VLAN ID. See “VLAN Context” on page A-176.
Use the following command to remove a VLAN association (the VLAN will no
longer be a TMS VLAN assigned to a zone):
Syntax: no vlan <VLAN ID>
Note You cannot delete a VLAN association if DHCP relay or routing is enabled on
the VLAN.
vlan <VLAN ID> ip address
To assign an IP address to the VLAN, enter the following command:
Syntax: vlan <VLAN ID> ip address < dhcp | <IP address/prefix length> >