TMS zl Management and Configuration Guide ST.1.1.100226

A-118

Command-Line Reference

IKEv1 Context

The IKEv1 context includes the commands for creating and editing an IKEv1

policy. The commands that you enter in the IKEv1 context do not take effect

until you apply them. If you exit before applying your commands, your settings

are lost.

This context is available only when the TMS zl Module is in routing mode.

Figure A-14. IKEv1 Context

To enter the IKEv1 context, enter the following command from the global

configuration context:

Syntax: ipsec ikev1<policy name>

Replace <policy name> with the name of the IKEv1 policy you are configur-

ing. This can be a new policy that you are creating or an existing policy that

you want to edit.

To verify your location in the CLI, check the prompt. In the IKEv1 context, the

prompt is ProCurve(tms-module-<slot ID>:ikev1)#.