TMS zl Management and Configuration Guide ST.1.1.100226

A-132
Command-Line Reference
IPsec Policy Context
Table A-39. IPsec Policy Traffic Selector Command Options
For example:
ProCurve(tms-module-<slot ID>:ipsec:<action>)# traffic-
selector protocol tcp local any port any remote host
10.2.3.3 port 89
This command is also available from the IPsec policy apply, IPsec policy
bypass, and IPsec policy deny contexts.
IPsec Policy Apply Context
This context includes commands that are specific to configuring IPsec policies
with the apply action. This context is available only when the TMS zl Module
is in routing mode.
Parameter Options
protocol •any
• <1-255>
•ah
•esp
•ip
•igmp
•gre
•l2tp
•ospf
•pim
• tcp [port <any | port number>] *
•udp [port <any | port number>] *
• icmp < any | echo** | timestamp** >
address •any
•host <IP address>
• network address/prefix length
• ip-range <start IP address> <end IP address>
• address <address object>
*If you use TCP or UDP for the traffic selector, you must enter port and specify a port
after both the local address and the remote address.
**If you select echo or timestamp, the tunnel must use manual keying instead of IKE
in your IPsec policy.