TMS zl Management and Configuration Guide ST.1.1.100226

A-133
Command-Line Reference
IPsec Policy Context
Figure A-16. IPsec Policy Apply Context
To enter the IPsec policy apply context, enter the following:
Syntax: action apply
To verify your location in the CLI, check the prompt. In the IPsec policy apply
context, the prompt is ProCurve(tms-module-<slot
ID>:ipsec:apply)#.
From the IPsec policy apply context, you can access the commands necessary
to create an IPsec policy that is actively applied to all traffic. You can:
■ Set the traffic selector (page A-136)
■ Set the IPsec proposal (page A-136)
■ Set the key exchange method (page A-135)
■ Enable IRAS for client-to-site VPNs (page A-144)
■ Set the advanced settings for the IPsec policy (page A-134)
■ Preview the IPsec policy (page A-136)
■ Apply the IPsec Policy (page A-135)
To exit the IPsec policy apply context, enter the following:
Syntax: exit
If you have not set all of the necessary configurations, you will be prompted
to do so and asked whether you actually want to exit.