TMS zl Management and Configuration Guide ST.1.1.100226

A-136
Command-Line Reference
IPsec Policy Context
preview
Before you apply the IPsec policy, you should preview it to make sure that
everything is correct. To preview your policy, enter the following command
from any IPsec policy context:
Syntax: preview
The command is also available from other contexts accessed through the
IPsec policy context.
proposal
The IPsec proposal specifies the IPsec mode, IPsec protocol, and the authen-
tication and encryption algorithms that secure the VPN connection. See “ipsec
proposal” on page A-81.
Syntax: proposal <proposal name>
Replace <proposal name> with the name of the proposal you want to apply
to this IPsec policy. This proposal must already by configured on the module.
For example:
ProCurve(tms-module-<slot ID>:ipsec:<action>)# proposal
testprop
traffic-selector
With this command, you configure the VPN traffic selector, which determines
the traffic to which this policy is applied. For example, the selector might
specify all IP traffic between 192.168.2.0/24 (a local network) and 192.168.3.0/
24 (a remote network). For a policy with the Apply action, the selected traffic
is the traffic that is sent and received (and secured) on the IPsec SA.