TMS zl Management and Configuration Guide ST.1.1.100226

A-144
Command-Line Reference
IPsec Policy Context
preview. Before you apply the IPsec policy, you should preview it to make
sure that everything is correct. To preview your policy, enter the following
command from any IPsec policy context:
Syntax: preview
The command is also available from other contexts accessed through the
IPsec policy context.
spi. This command sets the decimal number that uniquely identifies this
IPsec SA. You must match the SPI on the remote gateway. (In log files and
packet sniffers, this number may be represented in hexadecimal.)
Syntax: spi <number>
Replace <number> with a number between 256 and 2147483647 that will
represent this SA.
IPsec IRAS Context
This context includes the commands for configuring settings for the IPsec
Remote Access Server (IRAS), which provides IKE mode config. It is available
only when the TMS zl Module is in routing mode and when the IPsec policy
uses an IKEv1 policy of the client-to-site type.
Figure A-19. IPsec IRAS Context