TMS zl Management and Configuration Guide ST.1.1.100226

A-148
Command-Line Reference
IPsec Policy Context
Figure A-20. IPsec Policy Bypass Context
To enter the IPsec bypass context, enter the following command from the
IPsec policy context:
Syntax: action bypass
To verify your location in the CLI, check the prompt. In the IPsec policy bypass
context, the prompt is ProCurve(tms-module-<slot
ID>:ipsec:bypass)#.
To exit the IPsec policy bypass context, enter the following:
Syntax: exit
If you have not set all of the necessary configurations, you will be prompted
to do so and asked whether you actually want to exit.
The sections below document the commands available from the IPsec policy
bypass context. You can:
■ Set the direction (page A-149)
■ Set the traffic selector (page A-149)
■ Preview the IPsec policy (page A-150)
■ Apply the IPsec Policy (page A-149)