TMS zl Management and Configuration Guide ST.1.1.100226

A-149
Command-Line Reference
IPsec Policy Context
apply
Once you have configured all parts of the IPsec policy, you must apply the
policy. The apply command verifies that all required settings are configured
and then adds or edits the IPsec policy. (If the requirements are not met, the
command does not take effect, and an error message indicates which settings
are missing.) Enter the following command:
Syntax: apply
direction
To set the traffic direction to which the policy is applied, enter the following
command:
Syntax: direction <both | inbound | outbound>
The both option applies the bypass action to traffic both to and from the local
and remote addresses and ports specified in the traffic selector. The inbound
option applies the bypass action only to traffic from the remote addresses and
ports to the local addresses and ports. The outbound option applies the
bypass action only to traffic from the local addresses and ports to the remote
addresses and ports.
traffic-selector
With this command, you configure the VPN traffic selector, which determines
the traffic to which this policy is applied. For a policy with the bypass action,
this traffic is forwarded normally without being secured by an SA.
To set the traffic selector, enter the following command:
Syntax: traffic-selector protocol <protocol> local <address> remote address
<address> [port <port>]
The available options for the command are shown in Table A-39.