TMS zl Management and Configuration Guide ST.1.1.100226

A-150
Command-Line Reference
IPsec Policy Context
Table A-42. IPsec Policy Traffic Selector Command Options
For example:
ProCurve(tms-module-<slot ID>:ipsec:bypass)# traffic-
selector protocol tcp local 192.168.2.0/26 port any remote
host 192.168.2.1 port 443
preview
Before you apply the IPsec policy, you should preview it to make sure
everything is correct. To preview your policy, enter the following command:
Syntax: preview
For example:
Parameter Options
protocol •any
• <1-255>
•ah
•esp
•ip
•igmp
•gre
•l2tp
•ospf
•pim
• tcp [port <any | port number>] *
•udp [port <any | port number>] *
• icmp < any | echo** | timestamp** >
address •any
•host <IP address>
• network address/prefix length
• ip-range <start IP address> <end IP address>
• address <address object>
*If you use TCP or UDP for the traffic selector, you must enter port and specify a port
after both the local address and the remote address.
**If you select echo or timestamp, the tunnel must use manual keying instead of IKE
in your IPsec policy.