TMS zl Management and Configuration Guide ST.1.1.100226

A-159
Command-Line Reference
L2TP User Context
ProCurve(tms-module-<slot ID>:ipsec:apply)# apply
ProCurve(tms-module-<slot ID>:ipsec)# exit
ProCurve(tms-module-<slot ID>:config)# exit
L2TP User Context
The L2TP user context provides the commands for configuring L2TP authen-
tication either to the TMS zl Module’s local database. It also enables you to
configure the IP settings assigned to L2TP clients.
The commands that you enter in the L2TP user context do not take effect until
you apply them. If you exit before applying your commands, your settings are
lost.
Therefore, it is very important that you verify that the user group for the L2TP
user is configured on the TMS zl Module before you enter the L2TP user
context. Otherwise, you will have to exit without entering the apply com-
mand, causing you to lose any configurations that you have made.
(This context is available only when the TMS zl Module is in routing mode.)
Figure A-22. L2TP User Context