TMS zl Management and Configuration Guide ST.1.1.100226

A-161
Command-Line Reference
L2TP User Context
Replace <group> with the name of the user group for this user. The group
must already be configured on the TMS zl Module. (When you configure
firewall access policies that control this L2TP user’s access, you will configure
them for this user group.)
After entering this command, you will be prompted to input the user’s pass-
word. For the password, enter a case-sensitive string.
Note For the group name, you can use up to 14 alphanumeric characters plus the
space, period, comma, hyphen, (-), exclamation mark (!), string ($), at sign
(@), asterisk (*), and underscore (_). Do not use the hash sign (#) in the group
name.
See “user group” on page A-111 for complete information.
dns
Enter the following command to set the DNS servers for authenticated L2TP
clients:
Syntax: dns primary <server address> [secondary <server address>]
Replace <server address> with the IP address of a DNS server to which the
remote client is allowed access.
preview
Before you apply the user settings, you should preview them to make sure
everything is correct. To preview your user settings, enter the following
command:
Syntax: preview
For example:
ProCurve(tms-module-<slot ID>:config:l2tp)# preview
Preview L2TP Dial-in User
---------------------------------------------
User Authentication
User: user1
Password: ******
Policy Group Name: guest
Authentication Protocol: Any