TMS zl Management and Configuration Guide ST.1.1.100226

2-16
Initial Setup in Routing Mode
Initial Setup
3. Determine whether to disable routing or not:
• Disable routing if the switch only has an IP address on its management
VLAN.
• Leave routing enabled in these circumstances:
– The switch must route traffic for non-TMS VLANs.
– The switch will route external traffic for the TMS zl Module.
Initial Setup
At this point, you should have planned your deployment, installed your TMS
zl Module in an HP ProCurve 5400zl or 8400zl Series switch, and made
necessary configurations to this switch. This section teaches you how to
complete these tasks:
1. Access the host switch’s CLI
See “Access the Host Switch’s CLI” on page 2-17.
2. Ensure that the host switch recognizes the module.
See “Ensure That the Host Switch Recognizes the TMS zl Module” on page
2-17.
3. Access the TMS zl Module Services OS
See “Access the TMS zl Module Services OS Context” on page 2-19.
4. Activate the TMS zl Module
See “Activate the TMS zl Module” on page 2-20.
5. Optionally, register an IDS/IPS signature subscription
See “Register the IDS/IPS Signature Subscription” on page 2-25.
6. Boot the TMS zl Module Product OS
See “Boot the TMS zl Module to the Product OS” on page 2-30.
7. Access the TMS zl Module Product OS.
See “Access the TMS zl Module Product OS Context” on page 2-31.