TMS zl Management and Configuration Guide ST.1.1.100226

A-171
Command-Line Reference
RIP Context
ProCurve(tms-module-<slot ID>:config)# l2tp radius-auth
10.2.2.1
ProCurve(tms-module-<slot ID>:config)# l2tp radius-auth
domain-config hp.com ip-pool 10.2.2.2 10.2.2.200 dns
primary 192.168.12.200
RIP Context
The RIP context provides commands for configuring global RIP settings. It is
available only when the TMS zl Module is in routing mode.
Figure A-23. RIP Context
To enable RIP and access the RIP context, enter the following command from
the global configuration context:
Syntax: router rip
To verify your location in the CLI, check the prompt. In the RIP context, the
prompt is ProCurve(tms-module-<slot ID>:rip)#.
From this context you can:
■ Set the default metric
■ Enable or disable poison reverse
■ Redistribute routes—connected, static, and OSPF
■ Restrict addresses from advertisement