TMS zl Management and Configuration Guide ST.1.1.100226

A-176
Command-Line Reference
VLAN Context
For md5, replace <key ID> with the ID used in this area (1–255). Replace
<key> with the MD5 key, which is a string of up to 16 characters. For simple,
replace <password> with the password used in this area, a string of up 8
characters.
For the hello-interval option, replace <interval> with the number of sec-
onds between sending hellos to the neighbor (1–65535).
For the dead-interval option, replace <interval> with the number of sec-
onds that the module can fail to receive a hello from the neighbor before
considering the neighbor unreachable (1–65535).
For the retransmit-interval option, replace <interval> with the number of
seconds between sending LSAs (1–65535).
For the transmit-delay option, replace <delay> with the number of seconds
assumed for messages to reach the neighbor (1-3600).
no area
To delete an OSPF area, enter the following command:
Syntax: no area <area ID> [virtual-link < <neighbor ID> [ authentication < md5 | simple
<key> > | hello-interval <interval> | dead-interval <interval> | retransmit-interval
<interval> | transmit-delay <delay> > ]
VLAN Context
This context provides commands for configuring TMS VLAN settings. It is
available only when the TMS zl Module operates in routing mode. The VLAN
context for a specific VLAN is not available until you have assigned the VLAN
to a zone with the vlan <ID> zone command.