TMS zl Management and Configuration Guide ST.1.1.100226

A-177
Command-Line Reference
VLAN Context
Figure A-25. VLAN Context
To enter the VLAN context, enter the following:
Syntax: vlan <VLAN ID>
Replace <VLAN ID> with the VLAN ID.
To verify your location in the CLI, check the prompt. In the VLAN context, the
prompt is ProCurve(tms-module-<slot ID>:vlan-<VLAN ID>)#.
From the VLAN context, you can:
■ Change the VLAN’s zone
■ Assign the VLAN IP settings
■ Activate IGMP
■ Configure routing settings—RIP, OSPF, or PIM-Sparse Mode
ip address
To assign the VLAN IP settings, enter the following command:
Syntax: ip address < dhcp | <IP address/prefix length > >
If the TMS zl Module should receive a dynamic IP address on this VLAN, use
the dhcp option.
To assign the module a static IP address on this VLAN, replace <IP address/
prefix length> with the module’s static IP address and the prefix length for
its subnet.