TMS zl Management and Configuration Guide ST.1.1.100226

A-187
Command-Line Reference
Product OS Show Commands
■ Policy ID
To view the active connections on your network, enter the following com-
mand:
Syntax: show connections [sip <source IP address>] [dip <destination IP address>]
[szone <source zone>] [dzone <destination zone>] [pid <policy ID>]
Replace <source zone> with the source zone.
Replace <destination zone> with the destination zone.
Replace <source IP address> with the source IP address.
Replace <destination IP address> with the destination IP address.
Replace <policy ID> with the firewall policy ID number that permitted the
connection.
Note This command shows the active connections on the module, whereas the
connections values displayed on the Web browser interface dashboard win-
dow show both active and passive connections. Therefore, these two connec-
tion values may be slightly different. You should not be concerned with the
difference between the two values, unless:
■ The maximum connection threshold for a zone is reached
■ The number of connections is unreasonably high
show dhcp-relay
This command shows the DHCP relay configuration, including whether DHCP
relay is enabled globally, the IP addresses of DHCP servers, and the TMS
VLANs on which DHCP relay is enabled:
Syntax: show dhcp-relay
show gre
This command shows the GRE tunnels that are configured.
Syntax: show gre [tunnel name]
For detailed information about a specific GRE tunnel, including traffic statis-
tics, replace <tunnel name> with the name of the GRE tunnel. If you do not
include a tunnel name, all GRE tunnels are listed (with less information).