TMS zl Management and Configuration Guide ST.1.1.100226

2-18
Initial Setup in Routing Mode
Initial Setup
NOTE The ONE Services zl Module is a hardware platform that supports multiple
applications, or products (for a list of these applications, visit www.hp.com/
go/procurve). Recall that TMS also runs on a ONE zl Module even though the
module is purchased as a TMS zl Module with the product software loaded at
the factory.
Table 2-3. CLI Display of Services
At this point, you should take note of the following information, which you
will need to access the TMS zl Module CLI:
■ The slot for your TMS zl Module
In this example, two TMS zl Module are in installed, one in slot C and one
in slot E, as you can see in the Slot column for the row with Threat
Management Services zl Module for the Index Description.
■ The index number associated with the TMS zl Module
In this example, the index number is 2, as you can see in the Index
Description column. The index number might be different in your envi-
ronment. To learn why, see the section below.
Otherwise, simply make a note of the index number. You will need this
index number when you access the Product OS (see “Access the TMS zl
Module Product OS Context” on page 2-31). First, however, you must
activate the TMS zl Module. See “Activate the TMS zl Module” on page
2-20.
Understanding Index Numbers
The host switch assigns index numbers to all TMS zl Module and HP ProCurve
ONE Services zl Module products according to these rules:
■ The host switch always assigns index number 1 to the Services OS that
runs on ONE Services zl Modules and TMS zl Modules.
■ The host switch assigns index numbers to other products based on the
order in which the products boot. The first to boot is assigned index
number 2 and so forth.
Slot Index Description Name
C, D, E 1. Services zl Module services-module
C, E 2. Threat Management Services zl Module tms-module
D 3. Data Center Connection Manager dcm